1.制動液的加注
Fill the brake fluid
2.制動液中氣體的排除。制動液中混入氣體會影響制動性能。在更換零件下、清洗系統后要進行排氣。
Brake fluid gas excluded. Brake fluid mixed gas can affect braking performance. Under the replacement parts after cleaning system must be vented.
3.工作壓力調整。出廠時，壓力已作調整。使用后，若氣壓小于0.68·0.7MPa，應作調整。將壓力控制器的調整螺栓順時針旋轉，壓縮彈簧，使壓力達到0.68~0.7MPa，將螺母鎖緊。若氣壓過高，則作相反的調整。
Working pressure adjustment. At the factory, the pressure has been adjusted. After use, if the air pressure is less than 0.68 · 0.7MPa, should be adjusted. Clockwise rotation of the adjusting bolt of the pressure controller, the compression spring, to a pressure of 0.68 ~ 0.7MPa, the nut. If the pressure is too high, then make the opposite adjustment.
4.制動性能檢查。制動性能的好壞關系著運行的安全性和效率，經過拆修的 制動系統應檢查制動性能是否處于良好狀態。在平直、干燥的水泥路面上以24km/h速度行駛，用腳制動時其制動距離不大于9m。以30km/h速度行駛，點試制動，應迅速出現制動現象，且不偏跑。
Braking performance checks. Braking performance is good or bad relations with the safety and efficiency of operations, after overhaul of the brake system should be checked braking performance is in good condition. On the flat, dry cement road to 24km / h speed, foot brake when its braking distance of not more than 9m. To 30km / h speed, brake test point shall promptly appeared braking phenomenon, and not partial run.
5.保養。清潔。制動器的清潔能更好地發揮其制動效能，早期發現故障。檢查。經常檢查腳制動系統有無泄漏，各種接頭、連接部分有無松動，總液壓泵液面是否正常，管路是否暢通，無泄漏。檢查橡膠零件是否老化變質
Maintenance. Clean. Clean the brake can better play its braking performance, early detection of faults. Inspection. Always check for leaks foot brake system, all kinds of joints, loose connection portion, the total pump level is normal, the pipeline is smooth, no leaks. Check the rubber parts for aging deterioration